| Author |
Message |
Impman71
New member
Username: Impman71
Post Number: 24
Registered: 03-2007
| | Posted on Friday, May 28, 2010 - 05:39 am: | 
|
Hi,
I have removed the grub screw from the rewind knob but it refuses to come off!
I sprayed it with penetrating spray last night but still no joy!
I don't want to damage the frame counter by levering against it, any suggestions please.
Cheers,
Colin |
Impman71
New member
Username: Impman71
Post Number: 25
Registered: 03-2007
| | Posted on Friday, May 28, 2010 - 06:49 am: |
|
It's ok - I have just worked it out.
It is threaded & unscrews!
:-) |
Glenn
New member
Username: Glenn
Post Number: 795
Registered: 07-2006
| | Posted on Monday, July 05, 2010 - 03:58 am: |
|
A good rule of thumb to follow in cases like this - One grub screw present equals locking screw on threaded assembly. Two or three grub screws equally spaced around circumference equals push fit components with perhaps a locating groove for the screw points.
Does not always follow of course and cheaper equipment can have just one grub screw holding push fit knobs onto shafts, but remembering this 'rule' can prevent a frustrating evening and/or damaged/marked components. |
