| Author |
Message |
Mike_c
New member
Username: Mike_c
Post Number: 1
Registered: 11-2008
| | Posted on Friday, February 27, 2009 - 08:11 am: | 
|
I have a Prontor SVS (on a Graphic 35). The slow speeds were running very slow until I cleaned it. Now they are OK except for the 1 second, which runs at about 1/50, unless I leave the speed cam off, in which case it does about what it should. Grateful for any suggestions.
Mike Cohen |
Sevo
New member
Username: Sevo
Post Number: 33
Registered: 09-2008
| | Posted on Friday, February 27, 2009 - 11:12 am: |
|
Track the movements of all the pins chasing the different parts of the cam - usually one of them is stuck, bent or broken whenever some times can't be set. |
Mike_c
New member
Username: Mike_c
Post Number: 2
Registered: 11-2008
| | Posted on Saturday, February 28, 2009 - 03:54 am: |
|
Many thanks for the advice. Thers's nothing obvious--maybe I'll open up another working one and see if I can spot the difference. |
Rick_oleson
New member
Username: Rick_oleson
Post Number: 819
Registered: 07-2006
| | Posted on Saturday, February 28, 2009 - 04:42 am: |
|
Look for the possibility that you may have bent the pin when you placed the speed cam back on the shutter and then tightened the front panel down: if one of the pins misses its slot, the force of retightening the panel is likely to bend it. |
Mike_c
New member
Username: Mike_c
Post Number: 3
Registered: 11-2008
| | Posted on Saturday, February 28, 2009 - 08:09 am: |
|
Many thanks both. It was a bent pin (though in my own defence I should say I hadn't actually tightened the speed cam yet). Still it's all sorted, with a little gentle force. |
